Provide you with a one-stop spray drying solution

Home > Product > Closed-loop spray dryer

Closed-loop spray dryer

working principle

The BGL series closed-loop centrifugal spray dryer produced by our company is a specialized equipment for the manufacturing of powder materials such as new energy materials, ceramic materials, and cemented carbides. The product is manufactured in strict accordance with the industry standard JB/T12063-2014.

This system operates in a closed environment, using organic solvents such as ethanol, methanol, and acetone. The system employs inert gas (nitrogen) as the circulating gas. The nitrogen is heated by a heater and enters the drying tower. Liquid materials are transported to the centrifugal nozzle via a peristaltic pump or diaphragm piston pump and atomized into fine droplets by a high-speed centrifugal atomizer. These droplets mix with hot air distributed by a hot air distributor in the drying tower, undergoing rapid heat and mass exchange. In a very short period of time, they are dried into powdered or granular products. The organic solvents are discharged through a condenser and enter the recovery system. The nitrogen is heated again and recycled within the system. The interior of the drying system operates at a slight positive pressure, maintaining a certain positive pressure value. If the internal pressure rises or falls, the exhaust valve is automatically controlled by an instrument based on feedback from a pressure transmitter, ensuring pressure balance in the system.

Safety of closed drying tower

Unlike open drying towers, the raw materials used in closed drying towers contain flammable and explosive substances such as organic solvents and alcohol, which can easily lead to fires or even explosions in case of leakage.

2. The design/manufacturing, usage, and maintenance requirements for closed drying towers are stricter than those for open drying towers, especially regarding explosion protection and leakage prevention of the machinery

To ensure the utmost safety of the closed drying tower during use, the design must be tailored to the types and characteristics of organic solvents used. The selection of sealing gaskets and electrical equipment for switch valves must also comply with explosion-proof requirements. The overall explosion-proof design of the machine must be comprehensive and reliable. Any negligence or lack of professionalism may pose safety hazards to the equipment and lead to major accidents during production.

4. Overpressure relief and explosion venting technology are two safety devices with different functions but the same goal, set up to ensure safe production in closed-loop circulation: Overpressure relief refers to the safety device set up within the circulation system, with a safety operating nitrogen circulation flow pressure setting value of 3000Pa. It will automatically open the pneumatic valve to discharge the overpressure gas, so that the system can still restore the circulating flow balance pressure of 3000Pa. Explosion venting technology refers to the explosion-proof membrane of the explosion venting device, which will vent explosively in a directional manner in the instant that the set safety technical measures fail to work, the circulating system's flow pressure exceeds the set value to 0.05MPa (gauge pressure), or the residual oxygen content in the system exceeds 3% or reaches a high level, resulting in ignition or explosion, thus protecting equipment and personnel safety.

Due to the high safety requirements for closed drying towers, the first step to ensure safety is to choose equipment suppliers with good professionalism, good reputation, and proven performance in the industry, to ensure reliable guarantees in design, manufacturing, installation, and later maintenance.



Process flow diagram of BGL series closed-loop dryer

BGL -5-3

BGL-5-3 type centrifuge

Atomization, centrifugal granulation, fluid spray gun granulation, and multifunctional body dryer. Suitable for research and application of ceramic materials, new energy battery materials, alloy materials, and special metal materials in laboratories.


Technical description of BGL-5-2

The closed-loop centrifugal atomizing dryer, equipped with a magnetic filter, a high-temperature high-efficiency filter, and a collection vibration table, is suitable for demanding ceramic materials, metal alloy materials, and new energy materials.


Production-type BGL series closed-loop spray dryer